BRAKE DISCS AND DRUMS

DESCRIPTION:

Los discos y campanas de freno KMX FRICTION son indispensables para la seguridad y frenado de tu vehículo, fabricados bajo las más altas tecnologías de manufactura que garantizan un excelente desempeño y confort durante su operación y funcionamiento. Están fabricados con acero de alto contenido de carbono que se encarga de minimizar las vibraciones y aumentar la absorción de impactos, encuentralos en diferentes tipos como sólido y ventilados de acuerdo a las especificaciones OEM de cada fabricante.

WARRANTY:

This product is guaranteed by K-GROUP CORPORATION and its worldwide distributor network, applies for manufacturing defects or its materials and is subject to technical review by our experts.

Technical and quality characteristics:

Product with original type formulation

High resistance to corrosive agents

High carbon steel to minimize vibration and reduce noise.

Heat treated surfaces

Optimized design in ventilation channels, guaranteeing turbulent air flow, which generates greater cooling efficiency

Grinding Technology

Facilitates the settling of the tablet

Find a dealer

Facility

Remove the tire according to the vehicle manufacturer's instructions and safety protocol.
Remove the tie rod ends to release them from the steering knuckle (front wheels only).
Remove and inspect the current pads, hand tighten the caliper pins to keep the caliper closed and not lose any pins while removing or handling other items.
Remove the bolts holding the caliper to the steering knuckle and remove the caliper.
Remove the current brake disc
Install the new KMX friction brake disc
Check lubrication on all hardware
Reassemble the components in the order in which you disassembled them, checking for proper tightening of each component.
Request that the brake pedal be depressed several times to bleed the hydraulic drive system.

Expert Tips:

RECOMMENDATIONS WHEN INSTALLING

To carry out interventions on the brake system it is necessary to wait until it is completely cold, otherwise it may cause burns due to the temperature increase generated during its operation.
When replacing brake discs or brake drums it is recommended to replace the brake pads and/or brake shoe band.
It never hurts to perform preventive maintenance on the system;grease the caliper pins, check the displacement of the pistons and clean the brake system components.
When the installation is completed, remember to bleed the brake system and check the brake fluid level. Pump the brake system before starting the vehicle.

Pump the brake system before starting the vehicle.

DOWNLOADS:

BRAKE CYLINDERS